Dynojet Scooter Dyno SD-12 Manual - Manual (Page 40)

Model SD12 Scooter Dynamometer Installation Guide
C H A P T E R 3
Preventative Maintenance
3-10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PREVENTATIVE MAINTENANCE
This section contains basic preventative maintenance and troubleshooting
information.
To maintain proper dynamometer operation, Dynojet recommends you make routine
checks of the dyno.
• Drum—keep the drum clean and keep all objects clear of the drum.
• Carriage Slide—keep the carriage slide clean and lightly lubricated.
A DJUSTING THE B RAKE
Use the following instructions to prevent the brake from dragging.
1
Remove any vehicles from the dyno.
2 Push the brake pedal until it stops.
3 Using your hand, turn the drum.
4 Verify the brake is not dragging.
5 If the brake is dragging, adjust the brake.
Using a 7/16 open end wrench, adjust the brake stop bolt until there is no brake
drag.
Note: Adjusting the bolt too loose or too tight can cause brake drag.
Figure 3-6: Adjust the Brake
SD024
brake stop bolt