EFCO 5800 Series - Manual (Page 12)

straight into the gasket pocket.
STEP #2 INSTALL VERTICAL GASKET
Allow the horizontal gasket to run through. Butt the vertical gasket to the
the gasket on the vertical opening and press straight into the gasket pocket.
Cut the interior vertical gasket 1/8" longer than the daylight opening. Center
opening width. Center the gasket on the horizontal member and press
Cut the specified interior horizontal gasket 1 3/4" longer than the daylight
horizontal gasket at the open corners. Crowd in any excess gasket.
SECTION VI: INTERIOR GASKET INSTALLATION
STEP #1 INSTALL HORIZONTAL GASKET
VERTICAL GASKET
INTERIOR GASKET
9/2000
TIGHT TO THE HORIZONTAL.
VERTICAL GASKET BUTTS
RUNS THROUGH. THE
THE HORIZONTAL GASKET
PAGE 10