EFCO 8750XD User Manual
Page 22
EFCO 2012
Page 22
Series 8750XD Unitized Curtain Wall Installation Instructions
8. Finish installing starter sill sections as previously described until the installation is completed.
9. Push Stack Gasket WEA2 into gasket reglet beginning at one jamb condition and continuing to next jamb condition. Gasket should run continuously through
all corners and splices. Ensure that the gasket is not stretched while performing this task. See Figures 39 and 40.
10. Installation of the Dynamic Starter Sill is now complete.
Section 4 - Dynamic Starter Sill Preparation and Installation
KV25 Mullion
Dynamic
Loading Clip
KV30 Outside
Corner Dynamic
Loading Clip
Static Starter Sill
Stack Gasket WEA2
Figure 39
Figure 40
KV29 Inside
Corner Dynamic
Loading Clip
KV28 Right Hand
Jamb Dynamic
Loading Clip
KV25 Mullion
Dynamic
Loading Clip