Elecraft P3 SVGA Instructions - Manual (Page 13)

13
Parts Included
The following parts should be included in your kit. Check to ensure you have them all. If any parts are damaged
or missing, contact Elecraft for replacements (see Customer Service and Support, pg 4).
ILLUSTRATION DESCRIPTION QTY.
ELECRAFT
PART NO.
P3SVGA Circuit Board Assembly
ESD Sensitive.
1 E850482
Jackscrew Nut, 4-40 (may be mounted on
the Circuit Board Assembly Connector)
2 E700078
Lock Washer, Inside Tooth, #4 (may be
mounted on the Circuit Board Assembly
Connector)
2 E700010
Power cord assembly (used to connect the
P3 directly to a 10 to 15 VDC power supply).
NOTE: Do not attempt to power your P3 from
the K3’s 12V outlet unless it is labeled 1.0A
Max. See Power on pg 5 for details.
1 E850427