Elecraft P3 SVGA Instructions - Manual (Page 14)

14
Installation Procedure
Disconnect power and all cables from your P3.
Remove the six screws to free the top cover (Figure 7 ) and lift the cover off. There is a slot at
one end that you can use to lift the cover once it is free.
Whenever you remove screws from a panel, if one screw seems too tight to loosen
without damaging it, first loosen the other screws then try again. Sometimes one
screw binds in its hole when the other screws are tightened.
Figure 7. Preparing the P3 to Install the P3SVGA Board.
CAUTION: Touch an unpainted metal ground or wear a grounded wrist strap
before touching components or circuit boards inside the P3. See Preventing
Electrostatic Discharge Damage on page 12 for more information.
Remove the four jack screw nuts and lock washers to free the I/O board (Figure 7 )