Elecraft P3 SVGA Instructions User Manual
Page 16
16
Remove the plastic covering from the
AUX. DATA, EXT. DISPLAY
and
KEYBOARD
openings on the
rear cover, but leave the covering over the
SENSOR
opening (see Figure 10). The plastic cover will snap
apart at the score mark as you bend it away from the panel.
Figure 10. Removing Hole Covers.
Mount the P3SVGA board on the I/O board as shown in Figure 11. The connector on the P3SVGA
board mates with the connector on the I/O board that originally received the ribbon cable. Be sure the
connectors are aligned so that all pins engage. To avoid over-stressing the boards, place the I/O
board on a firm surface. You may need to rock the P3SVGA board slightly while pressing down to
“walk” the pins into the connector like you did when removing the ribbon cable earlier.
Figure 11. Mating the I/O and P3SVGA Boards.