ETS-Lindgren 1052 Antenna Tower Positioner - Manual (Page 20)

20 | Assembly Instructions
8. Install extension legs.
• Position the carrier at the winch assembly.
• Raise the entire unit until it is in an upright position, resting on the base.
• Install the extension legs into the base with each leg oriented so the
pin hole is nearest to the bottom side of the leg.
• Secure each extension leg with a lock pin.
• Use thumbscrews to make vertical adjustments to legs.
9. Thread cable through cable guide—Insert the feed cable for the antenna
into the cable guide to reduce stress on the cable and antenna connector.
Mount an antenna to the boom by threading the mounting knobs up through the
holes in the boom and into the mounting receptacle on the antenna.
To install guy ropes, see Using Guy Ropes on page 22.