ETS-Lindgren 1052 Antenna Tower Positioner - Manual (Page 7)

Introduction | 7
1.0 Introduction
The ETS-Lindgren Model 1052
Antenna Tower Positioning
System is designed for portable
antenna positioning in EMC
compliance testing.
A hand winch and pulley drive
system elevates the antenna
carrier from one to four meters.
Maximum carrier load capacity
is 11.3 kg (24.91 lb) on the tip of
the cross boom. For loads
measured on the center of the
cross boom, the capacity is
22.7 kg (50.04 lb).
The mast is constructed of a high density fiberglass reinforced polymer with a
high degree of immunity to structural deterioration from environmental elements.
The base is an aluminum four-leg design for maximum support and portability.
The design of the Model 1052 allows easy assembly and usage.
ETS-Lindgren Product Information Bulletin
See the ETS-Lindgren Product Information Bulletin included with your shipment
for the following:
• Warranty information
• Safety, regulatory, and other product marking information
• Steps to receive your shipment
• Steps to return a component for service
• ETS-Lindgren calibration service
• ETS-Lindgren contact information