ETS-Lindgren 4610 Royce Field Site Source (Archived) - Manual (Page 23)

Installation and Operation | 23
6.0 Installation and Operation
Before connecting any components, see Safety
and Regulatory Information on page vii.
The Model 4610 Royce Field Site Source generates a 10 MHz fundamental
frequency and harmonics at 10 MHz increments up to 600 MHz. A rod antenna is
provided which should be connected to the Type N connector located on the top
of the unit. This Type N output can also be connected to a spectrum analyzer to
verify performance of the unit.
Power to the Model 4610 is provided by rechargeable sealed lead-acid batteries
(two are provided at six volts DC each). In the detented position of the power
switch, power is provided to the unit and a power on indicator should be
illuminated. When battery voltage discharges to a predetermined minimum level,
a low battery indicator will illuminate (should the batteries experience a deep
discharge, neither light will be illuminated). At this point, the power switch should
be placed in the Off/Charge position and batteries charged using the
charger port located adjacent to the power switch. Charging can be made with
either the 100 VAC/60 Hz charger or the optional 220 VAC/50 Hz charger.
Archived 3/18/10