Fotodiox Aputure Trigmaster Plus - Manual (Page 3)

4
Components
3
Body
1. Antenna 12. Battery holder
2. Status indicator lamp 13.Copper nut
3. Trigger button 14. Power switch
4. Channel indicator lamp 15. Rope hole
5. Channel switch
6. Hot shoe connection
7. Function switch
8. Studio flash sync hole
9. Camera remote shutter hole
10. PC_IN hole
11. Fastening nut
16. Remote cable
17. Sync cable
18. PC cable
19. Sync output convertor
20.Battery: two AAA1.5V batteries
Accessories
Battery Setup
Trigmaster Plus 2.4G uses two AAA
1.5V batteries, which can normally be
used up to 100 hours. To insert the
battery, open the battery hatch by
following the arrow's direction; then
insert the battery according to the +/-
icons, then close the battery hatch.
Trigmaster Plus 2.4G contains 6 possible
channels. Set all the Trigmaster Plus 2.4G
units on the same channel before use.
One transmitter can work with multiple
receivers to control multiple flashes or
m u l t i p l e c a m e r a s s i m u l t a n e o u s l y.
Trigmaster Plus 2.4G can also be used by
multiple photographers working together
to control different cameras, but each
photographer must set their own channel
different from others to avoid signal
disturbance.
Channel Setting
When Trigmaster Plus 2.4G works as a
flash receiver, the function switch should
be set to RX. When Trigmaster Plus 2.4G
works as a camera remote trigger, camera
remote receiver or flash trigger, the
function switch should be set to TX/RX.
Function Setting
Diagram of Channel Setting
Diagram of Function Switch Setting
1 2 3 4 5 6
Channel
Switch Settings
1
2
3
9
4
5
6
7
8
10
11
15
12
13
14
16 17 18 19 20