Fotodiox Aputure Trigmaster Plus - Manual (Page 6)

10 9
Type: 2.4G wireless remote system
Transmitter distance:
120 meters (open area)
Channel: 6 different channels
Sync-speed: 1/250 sec
Continuous trigger frequency: 8 frames/second
Dimensions: 80x48x27 mm
Power life standby: 2000 hours.
Continuous working time: 100 hours.
Specifications
Troubleshooting
For Your Safety
Do not disassemble or modify
Failure to observe this precaution could result in electric shock or product
malfunction. Should the product break open as the result of a fall or other
accident, remove the batteries.
Keep dry
Do not handle with wet hands or immerse in or expose to water or rain.
Failure to observe this precaution could result in fire or electric shock.
Do not use in the presence of flammable gas
Failure to observe this precaution could result in explosion or fire.
Keep out of reach of children
This device contains small parts which may pose a choking hazard.
Consult a physician immediately if a child swallows any part of this device.
Do not expose to high temperatures
Do not leave the device in a closed vehicle under the sun or in other areas
subject to extremely high temperatures. Failure to observe this precaution
could result in fire or in damage to the casing or internal parts.
Observe precaution when handling batteries
Use only batteries listed in this manual. Do not mix old and new
batteries or batteries of different types.
Do not short or disassemble.
Do not attempt to insert batteries upside down or backwards.
Batteries are prone to leakage when fully discharged. To avoid damage
to the product, be sure to remove the batteries when leaving the product
Unattended for prolonged periods or when no charge remains.
Should liquid from the batteries come into contact with skin or clothing,
rinse immediately with fresh water.
Q: Unable to trigger flash or camera shutter
A: Make sure the battery is installed and receiver power switch turned on.
A: Set the transmitter and receiver to the same channel.
A: Make sure the transmitter and receiver are set to the correct function
switch(TX/RX or RX).
A: Make sure the hot shoe mount or PC cable are completely connected.
Q: Camera shoots but doesn't focus
A: Make sure the lens focus mode is set to AF, not MF.
Q: Operating distance limited
A: Check if the battery is exhausted
A:Try to move transmitter's location and angle, as following
A: Check if there is barrier between transmitter and receiver
Q: Signal Disturbance or Shooting Interference
A: Make sure Trigmaster plus 2.4G channel switch settings are different than
other photographers.
To prevent damage to your product or injury to yourself or to others, read the
following safety precautions in their entirety before using this equipment. Keep
these safety instructions where all those who use this equipment will read
them.
One Trigmaster Plus 2.4G held in hand(function switch set to TX/RX), the other
one connected with flash (function switch set to RX). Half-press the trigger
button first, then press the channel switch, and the connected flash will be
triggered and flash at the same time.
Remote Test (Tested by two Trigmaster Plus 2.4G)
Tips: To avoid channel changing, make sure to half-press the trigger button
before pressing the channel switch, and release the trigger button after
releasing the channel switch.
When Trigmaster Plus 2.4G status indicator lamp is red and flickering,
the battery power is low.