General Hydroponics WaterFarm 8-pack - Manual (Page 2)

WATERFARM 8-PACK PARTS ASSEMBLY
STEP 1
Disassemble the Float Valve
and insert the threaded end
with the washer from the inside
of the Controller, through the
predrilled hole.
Secure the Float Valve from the outside of the
Controller with the brass nut. Coat the remaining
threads with the Pipe Thread Compound and
screw on the brass 1/2” barbed hose fitting. WATERFARM 8-PACK PARTS:
1) Controller and Lid
2) Reservoir and Lid
3) Growing Chambers (8)
4) Individual Reservoirs (8)
5) Drip Rings (8)
6) Pumping Column Support Tubes (8)
7) Pumping Columns (8)
8) Air Lines (9)
9) Float Valve
10) Drain Level Tube
11) Parts Bag
½” Barbed, Elbow Fittings (4)
½” Barbed, Straight Fittings (15)
Drain Level Tube (DLT) Clip (1)
12) Circulating Pumping Column
13) Single Outlet Air Pump
14) Dual Diaphragm Air Pump
15) ½” Blue tubing (2x9’)
16) Flora Series Nutrients
1
5
8 9 10 12
13
14
15
16
11
6
7
2 3 4
Pipe Thread Compound