General Hydroponics WaterFarm 8-pack - Manual (Page 3)

ASSEMBLY ASSEMBLY
STEP 3
Insert a ½” barbed, elbow fitting into the grommet on the side of the Controller. From the
inside of the Controller attach the Circulating Pumping Column to the other side of the
½” barbed elbow and run the Air Line through the predrilled hole. Connect an Air Line to
the Single Output Pump and the other end to the Circulating Pumping Column airline.
STEP 4
Place the lid on the Controller and remove the tear away
strip for easier opening and closing of the lid. Place the
Reservoir on top of the Controller and remove the tear
away strip
Insert a ½” barbed, straight fitting and connect the
Controller to the Reservoir with the ½” Blue Tubing.
Measure before cutting the tubing to avoid cutting it
too short and the tube kinking.
STEP 5
Assemble the 8 individual growing units by inserting a ½” barbed, straight fitting
in each of the opposing ½” grommets in 6 of the Individual Reservoirs. Insert a ½”
barbed, straight fitting and a ½” barbed, elbow fitting in the opposite grommet of the
last 2 Individual Reservoirs.
STEP 2
Insert the DLT Clip into the predrilled hole in the handle of the Controller and insert
the Drain Level Tube into the ½” grommet at the bottom. Secure the Drain Level Tube
upright in the DLT Clip during normal operation. The Drain Level tube can be rotated
level with the bottom of the controller to drain the system.