Vermont Casting RHE42 - Manual (Page 32)

32 10000836
Vermont Castings, Majestic Products RHE Natural Vent Insert
On units fitted with a Honeywell brand control
valve the location of the control knobs and
the ignitor button may vary slightly from those
shown in Figure 51. The Honeywell extension
pieces are visually different in design and are
not interchangeable with the RN/RP knobs
shown in Figure 51.
2. Install the hanging brackets. (Fig. 52)
3. Install bracket on each side of the cabinet. (Fig. 56)
4. Install the two ceramic pieces inside the bay win-
dow. (Fig. 48)
5. Install the bay window by hanging it onto the lower
tabs of the hanging brackets. (Fig. 51)
6. Install top louvre by engaging the oblong holes with
the upper tabs of the hanging brackets. (Fig. 54)
7. Install brass trim to the steel frame. (Fig. 55)
Fan Control Box
KT205
Fig. 49 Remove fan control box.
Fan Control
Box
Extension
Bracket
KT207
Fig. 50 Attach the control box to the bracket and install
bracket into the cabinet.
Extension
Knobs
KT204a
Fig. 51 Install the knob extensions. (RN/RP models Only)
KT211
Fig. 54 Engage the slots in the upper grille top louvre with
the upper tabs of the hanging bracket.
KT212a
Fig. 55 Attach magnets and brass trim to the steel frame.
KT210
Fig. 53 Hang the window grille or the steel frame onto the
lower tabs of the hanging brackets.
Hanging Bracket
KT209a
Fig. 52 Hanging bracket alignment.
FP1270
Fig. 56 Bracket for HEBTKP.