Chief Manufacturing PSH-2000 - Manual (Page 5)

Installation Instructions Model: PSH-2000
5
ASSEMBLE STATIC BRACKETS
1. Using key (160), loosely install screws (60) through
latch (40) and spacers (50) into threaded holes in
bracket (20) (See Figure 5). Ensure latch (40) is
installed on the end of bracket (20) with the square
cutout.
Figure 5: Latch Assembly
2. Repeat for remaining bracket (20).
3. Tighten screws (60) only as required to keep latches
(40) from freely slipping on bracket (20). Latches are
designed to slide; do not overtighten screws (60).
4. Slide latch (40) to fully open (raised) position.
5. Using Phillips screwdriver, install screw (70) through
slotted hole in latch (40) into threaded hole in bracket
(20) (See Figure 6). Tighten only as required to take
up slack; overtightening will close latch preventing
mounting button installation.
• If latch begins to close, loosen screw (70) and pull
latch (40) to open position.
Figure 6: Open Latch
ASSEMBLE SIDE SUPPORTS
1. Using key (150), loosely install support (30) to plate
(10) with screws (130) (See Figure 7). Ensure lip of
support (30) covers edge of plate (10).
2. Repeat for other 3 corners.
3. Once all screws (130) are installed, tighten securely.
Figure 7: Side Support Assembly
(40)
(60)
(50)
(20)
(4 Places)
(4 Places)
Square
Cutout
Threaded
Hole in
Bracket
(4 Places)
(70)
Slotted Hole
Threaded Hole
in Latch (40)
Threaded Hole
in Bracket (20)
in Latch (40)
(130)
(10)
(30)