Jeep 2013 Patriot - User Guide - Manual (Page 56)

Receiving A Call – Accept (And End)
• When an incoming call rings/is announced on Uconnect ® , press the Phone button
.
• To end a call, press the Phone button .
Mute (Or Unmute) Microphone During Call
• During a call, press the “Voice Command” button .
• (After the BEEP), say “mute” (or “mute off”).
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the “Voice Command” button .
• (After the BEEP), say “transfer call”.
Changing The Volume
• Start a dialogue by pressing the “Phone” button , then adjust the volume
during a normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable
level while the Uconnect ® system is speaking. Please note the volume setting for
Uconnect ® is different than the audio system.
WARNING!
• Any voice commanded system should be used only in safe driving conditions
following applicable laws regarding phone use. Your attention should be
focused on safely operating the vehicle. Failure to do so may result in a
collision causing you and others to be severely injured or killed.
• In an emergency, to use Uconnect ® Phone, your mobile phone must be:
• turned on,
• paired to Uconnect
® Phone,
• and have network coverage.
Uconnect® VOICE COMMAND
Voice Command Operation
• The Uconnect ® Voice Command system allows you to control your AM, FM radio,
satellite radio, disc player, HDD, Uconnect ® Phone, a memo recorder, and
supported portable media devices.
• When you press the “Voice Command” button located on the radio
faceplate or steering wheel, you will hear a beep. The beep is your signal to give a
command. If you do not say a command within a few seconds, the system will
present you with a list of options. If you ever wish to interrupt the system while it
lists options, press the “Voice Command” button
, listen for the BEEP, and
say your command.
ELECTRONICS
54