Universal garage door opener (homelink®), Before you begin programming homelink, Universal garage door opener (homelink – Jeep 2013 Patriot - User Guide User Manual

Page 61: Electronics

Advertising
background image

Sound Horn With Lock

• To turn the horn chirp on or off when the doors are locked:

• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds.

Then, press the PANIC button while still holding the LOCK button.

• Release both buttons at the same time.

Flashing Lights With Lock

• The turn signal lights flashing, when the doors are locked or unlocked, feature can

be turned on or off. To turn this feature on or off:

• Press and hold the UNLOCK button for at least 4 seconds, but no longer than

10 seconds. Then, press and hold the LOCK button while still holding the
UNLOCK button.

• Release both buttons at the same time.

UNIVERSAL GARAGE DOOR OPENER (HomeLink®)

• HomeLink

®

replaces up to three hand-held transmitters that operate devices such

as garage door openers, motorized gates, lighting or home security systems. The
HomeLink

®

unit is powered by your vehicles 12 Volt battery.

• The HomeLink

®

buttons that are located in the overhead console or sunvisor

designate the three different HomeLink

®

channels.

• The HomeLink

®

indicator is located above the center button.

Before You Begin Programming
HomeLink®

• Be sure that your vehicle is parked

outside of the garage before you begin
programming.

• For more efficient programming and

accurate transmission of the radio-
frequency signal it is recommended
that a new battery be placed in the
hand-held transmitter of the device
that is being programmed to the
HomeLink

®

system.

• Erase all channels before you begin programming. To erase the channels, place

the ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink

®

buttons (I and III) for up 20 seconds or until the red indicator flashes.

NOTE:

• Erasing all channels should only be performed when programming HomeLink

®

for

the first time. Do not erase channels when programming additional buttons.

• If you have any problems, or require assistance, please call toll-free 1–800–355–

3515 or, on the Internet at www.HomeLink.com for information or assistance.

ELECTRONICS

59

Advertising