Kontron CP3002 uEFI - Manual (Page 18)

Main Setup CP3002/-RC/-RA uEFI BIOS
Page 12 ID 1042-8946, Rev. 3.0
P R E L I M I N A R Y
2.5 Serial Port Console Redirection
This screen provides information about functions for specifying the Serial Port Console Redi-
rection configuration settings. Console redirection can be used to remotely operate system set-
tings and the EFI console.
2.5.1 COM0
On the CP3002 the COM0 port corresponds to the COMA port (RS-232) and is available either
on the 8HP extension module or on the rear I/O.
On the CP3002-RA/-RC the COM0 port corresponds to the COMA port (RS-232) and is avail-
able only on the rear I/O.
2.5.1.1 Console Redirection
Default setting: Disabled
2.5.1.2 Console Redirection Settings
For information about this function, refer to Chapter 2.5.5 in this manual.
A p t i o S e t u p U t i l i t y - C o p y r i g h t ( C ) 2 0 0 9 A m e r i c a n M e g a t r e n d s , I n c .
M a i n B o o t S e c u r i t y S a v e & E x i t
COM0
Console Redirection [Disabled]
 Console Redirection Settings
COM1
Console Redirection [Disabled]

Console Redirection Settings
COM4
Console Redirection Port Is Disabled
Serial Port for Out-of-Band Management/
Windows Emergency Management Services (EMS)
Console Redirection [Disabled]
Out-of-Band Mgmt Port [COM0]
Data Bits 8
Parity None
Stop Bits 1
Terminal Type [VT-UTF8]
 : Select Screen

: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3 Optimized Defaults
F4: Save ESC: Exit
Ve r s i o n 2 . 0 0 . 1 2 0 1 . C o p y r i g h t ( C ) 2 0 0 9 A m e r i c a n M e g a t r e n d s , I n c .
SETTING DESCRIPTION
Disabled Use this setting to disable console redirection for COM A (RS-232).
Enabled Use this setting to enable console redirection for COM A (RS-232).