Kontron CP3002 uEFI - Manual (Page 43)

CP3002/-RC/-RA uEFI BIOS The uEFI Shell
ID 1042-8946, Rev. 3.0 Page 37
P R E L I M I N A R Y
6.2.1 kboardconfig uEFI Shell Command
kboardconfig
FUNCTION: Configure non-volatile board settings
SYNTAX: kboardconfig
kboardconfig [-?|<device>|<setting>]
where:
? Show online help
<device> Specify device from list
<setting> Select configuration type
DESCRIPTION: The kboardconfig command is used to configure non-volatile board
settings.
USAGE: Show all possible configurations
COMMAND / RESPONSE:
Shell> kboardconfig
Control nonvolatile board settings
Example: kboardconfig
pxe: Select PXE boot network adapter ([disabled] all eth_a eth_b
eth_c eth_d)
StorageOrom: Launch Storage PCI OpROM (disabled [enabled])
HyperThreading: Enable Hyper Threading technology (disabled
[enabled])
CpuTurbo: Enable CPU turbo mode technology (disabled [enabled]
CpuC: Enable C states when the CPU is not 100% utilized (disabled
[enabled])
PrimaryDisplay: Select primary display device ([auto] igd peg pci)
SataMode: Determines how SATA controller(s) operate ([ide] ahci
raid)
com_a: Com A port configuration ([rear] extension)
com_b: Com B port configuration (rs232 [rs422])
gbe_a: GbE A port configuration ([front] rear)
gbe_b: GbE B port configuration ([front] rear)
vga: VGA port configuration (auto [front] rear disabled)
wr_prot_eeprom: System EEprom write protection ([disabled]
enabled)
wr_prot_sata: Onboard Sata flash write protection ([disabled]
enabled)
wr_prot_spi: EFI spi flash write protection ([disabled] enabled)
Note: not all options are available on all variants.
Show allowed settings e.g. for “PrimaryDisplay”:
Shell> kboardconfig PrimaryDisplay
PrimaryDisplay: Select primary display device
PrimaryDisplay == auto
Allowed options: auto, igd, peg, pci