Kontron CP3002 uEFI - Manual (Page 28)

Boot Setup CP3002/-RC/-RA uEFI BIOS
Page 22 ID 1042-8946, Rev. 3.0
P R E L I M I N A R Y
3.1.2 uEFI Boot
This function is used to enable or disable uEFI boot from disks.
Default setting: Enabled
3.1.3 Setup Prompt Timeout
This integer function is used to set an additional time the POST should wait for the operator to
press the key to enter setup. The time is entered in seconds.
Default setting: 2
3.1.4 Bootup NumLock State
This function is used to set the state of the keyboard’s numlock function after POST.
Default setting: On
3.1.5 CSM16 Module Version
This function provides display-only information concerning the CSM Module and is intended for
internal use only.
3.1.6 GateA20 Active
This function is used to enable or disable GateA20.
Default setting: Upon Request
SETTING DESCRIPTION
Disabled Use this setting to prevent the system from booting native uEFI-aware operating systems
from disks.
Enabled Use this setting to enable booting of native uEFI-aware operating systems from disks, if
present, and in boot order.
SETTING DESCRIPTION
1
...
65535
Use one of these settings to specify the setup prompt timeout.
SETTING DESCRIPTION
On Use this setting to switch on the keyboard’s numlock function after POST.
Off Use this setting to switch off the keyboard’s numlock function after POST.
SETTING DESCRIPTION
Upon Request Use this setting to disable GateA20 in the uEFI BIOS.
Always Use this setting to prevent the system from disabling GateA20.