Kontron CP346 - Manual (Page 44)

Installation CP346
Page 3 - 4 © 2005 Kontron Modular Computers GmbH ID 27253, Rev. 03
P R E L I M I N A R Y
3.2 Standard Installation Procedures
To install the CP346 in a system proceed as follows:
1. Ensure that the safety requirements indicated Chapter 3.1 are observed.
2. Ensure that the board is properly configured for operation in accordance with application
requirements before installing. For information regarding the configuration of the CP346
refer to Chapter 4. For the installation of CP346 specific peripheral devices and rear I/O
devices refer to the appropriate chapters in Chapter 3.
3. To install the CP346 perform the following:
1. Ensure that no power is applied to the system before proceeding.
2. Carefully insert the board into the slot designated by the application requirements for
the board until it makes contact with the backplane connectors.
3. Using the ejector handle, engage the board with the backplane. When the ejector han-
dle is locked, the board is engaged.
4. Fasten the front panel retaining screws.
5. Connect all external interfacing cables to the board as required.
6. Ensure that the board and all required interfacing cables are properly secured.
4. The CP346 is now ready for operation. For operation of the CP346, refer to appropriate
CP346 specific software, application, and system documentation.
Warning!
Failure to comply with the instruction below may cause damage to the
board or result in improper system operation.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the CP346 nor other system boards are physically damaged by
the application of these procedures.
Warning!
When performing the next step, DO NOT push the board into the back-
plane connectors. Use the ejector handles to seat the board into the back-
plane connectors.