Kontron CP-RIO6-001-HD-VGA - Manual (Page 20)

Introduction CP-RIO6-001-HD-VGA
Page 1 - 6 ID 1052-4138, Rev. 1.0
1.3 Technical Specification
Table 1-1: CP-RIO6-001-HD-VGA Main Specifications
CP-RIO6-001-HD-VGA SPECIFICATIONS
Fro
nt
Panel
Interfaces
Analog Video VGA: 15-pin, D-Sub connector, J20
Ethernet Two Gigabit Ethernet interfaces implemented as a dual RJ-45 connector,
J18A/B
USB Two USB 2.0 interfaces on type A connectors, J16 and J17
COM One COM interface implemented as a single RJ45 connector, J19
Onboard Interfaces
SATA Two SATA interfaces implemented as two onboard connectors:
• One SATA connector, J13, for connecting a SATA device via a
SATA cable
• One SATA connector, J15, for installing an optional 2.5” SATA
HDD/SSD
USB One onboard connector, J14, for connecting one USB 2.0 NAND Flash
module
COM One COM port implemented as one 10-pin, 2.54 mm onboard connector,
J8
Fan Two fan connectors, J6 and J7, with sense inputs for monitoring the fan
speed
CompactPCI Three CompactPCI connectors, rJ3, rJ4 and rJ5, for connecting the mod-
ule to the backplane
GPIO Two GPIO interfaces on the two-pin connectors J10 and J11
General
Temperature Range Operational: 0°C to +60°C Standard
-40°C to +85°C E2 (optional)
Storage: -55°C to +85°C Without any additional components
Mechanical 6U, 4HP, CompactPCI-compliant form factor
Dimensions 233.35 mm x 80 mm
Board Weight 228 g (without USB NAND Flash module and/or HDD/SSD)
Note ...
When additional components are installed, refer
to their operational specifications as this will influ-
ence the modules’ operational and storage tem-
perature.