Kontron CP-RIO6-001-HD-VGA - Manual (Page 43)

CP-RIO6-001-HD-VGA Installation
ID 1052-4138, Rev. 1.0 Page 3 - 5
3.3 Rear I/O Module Removal Procedures
To remove the rear I/O module proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed.
2. Ensure that no power is applied to the system before proceeding.
3. Disconnect any interfacing cables that may be connected to the rear I/O module.
4. Unscrew the two front panel retaining screws.
5. Disengage the rear I/O module from the backplane by first unlocking the ejection handles
and then by pressing the handles as required until the rear I/O module is disengaged.
6. After disengaging the rear I/O module from the backplane, pull it out of the slot.
7. Dispose of the rear I/O module as required.
3.4 Installation of Peripheral Devices
The CP-RIO6-001-HD-VGA is designed to accommodate a variety of peripheral devices whose
installation varies considerably. The following chapters provide information regarding installa-
tion aspects and not detailed procedures.
3.4.1 USB Device Installation
The CP-RIO6-001-HD-VGA supports all USB Plug and Play computer peripherals (e.g.
keyboard, mouse, printer, etc.).
Warning!
Care must be taken when applying the procedures below to ensure that
neither the rear I/O module nor system boards are physically damaged by
the application of these procedures.
Warning!
Even though power may be removed from the system, the rear I/O mod-
ule’s front panel cables may have power applied which comes from an ex-
ternal source.
In addition, these cables may be connected to devices that can be dam-
aged by electrostatic discharging or short-circuiting of pins.
It is the responsibility of the system designer or integrator to ensure that
appropriate measures are taken to preclude damage to the system or in-
jury to personnel which may arise from the handling of these cables (con-
necting or disconnecting).
Kontron disclaims all liability for damages or injuries resulting from failure
to comply with the above.
Note ...
All USB devices may be connected or removed while the host or other
peripherals are powered up.