2 rear i/o module installation procedures, 2 rear i/o module installation procedures - 4, Installation cp-rio6-001-hd-vga – Kontron CP-RIO6-001-HD-VGA User Manual

Page 42

Advertising
background image

Installation

CP-RIO6-001-HD-VGA

Page 3 - 4

ID 1052-4138, Rev. 1.0

3.2

Rear I/O Module Installation Procedures

To perform an installation of the rear I/O module in a system, proceed as follows:

1. Ensure that the safety requirements indicated Chapter 3.1 are observed.

2. Ensure that the rear I/O module is compatible with the CPU board and the backplane pri-

or to installation.

3. If appropriate, ensure that the onboard peripheral devices are properly installed prior to

installation.

4. Ensure that no power is applied to the system before proceeding.

5. Carefully insert the rear I/O module into the slot designated by the application require-

ments for the rear I/O module until it makes contact with the backplane connectors.

6. Using both ejector handles, engage the rear I/O module with the backplane. When the

ejector handles are locked, the rear I/O module is engaged.

7. Fasten the two front panel retaining screws.
8. Connect all external interfacing cables to the rear I/O module as required.
9. Ensure that the rear I/O module and all required interfacing cables are properly secured.

The rear I/O module is now ready for operation.

Warning!
Failure to comply with the instruction below may cause damage to the
rear I/O module or result in improper system operation.

Note ...
Ensure that the system components are properly configured for use with
the rear I/O module.

Warning!

Even though power may be removed from the system, the rear I/O mod-
ule’s front panel cables may have power applied which comes from an ex-
ternal source.

In addition, these cables may be connected to devices that can be dam-
aged by electrostatic discharging or short-circuiting of pins.

It is the responsibility of the system designer or integrator to ensure that
appropriate measures are taken to preclude damage to the system or in-
jury to personnel which may arise from the handling of these cables (con-
necting or disconnecting).

Kontron disclaims all liability for damages or injuries resulting from failure
to comply with the above.

Warning!

When performing the next step, DO NOT push the rear I/O module into the
backplane connectors. Use the ejector handles to seat the rear I/O module
into the backplane connectors.

Advertising