Kontron AT890X Full-Size CLI - Manual (Page 202)

Utility Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 5 - 4
Format
download bootloader <url>
Mode Privileged EXECEXEC
5.2.7 show startupconfig
This command shows the slots for kernel/initrd/application/config or all possible
configured combinations of the above
Format
show startupconfig {application | kernel | initrd | star-
tup | config | all}
Mode Privileged EXEC
5.2.8 startupslot <slotnumber> config
This command configures the startup slot with the supplied values from the other slots.
It will also check the configuration for consistency and flag any errors.
Format
startupslot <slotnumber> config <F,1-99> application
<F,1-9> initrd <F,A,B> kernel <F,A,B>
Mode Global Config
5.2.9 startupslot <slotnumber> activate
This command sets the startup slot to active and will use this in all subsequent reboots.
Using [once] at the end of the command will set the startup slot to be used once during
the next restart. The start sequence will reset the startup slot to the previously installed
one. This enables a try-once with automatic rollback in case of error.
Format
startupslot <slotnumber> activate [once]
Mode Global Config
5.3 ATCA commands
5.3.1 set board sensor threshold
This command sets a new threashold value for a sensor. The <record-id> (of SDR) for
a specific sensor is displayed by the related “show” command
Format
set board sensor threshold <record-id> <value-type>
<value>
Mode Privileged EXEC
<Value-type>
•
lower-non-critical Set lower non-critical threshold value
• lower-critical Set lower critical threshold value
• lower-non-recover Set lower non-recoverable threshold value
• upper-non-critical Set upper non-critical threshold value
• upper-critical Set upper critical threshold value
• upper-non-recover Set upper non-recoverable threshold value