9 disconnect, 10 show telnet, 11 show telnetcon – Kontron AT890X Full-Size CLI User Manual
Page 252: Disconnect - 10, 10 show telnet - 10 6.3.11 show telnetcon - 10
Management Commands
AT8901/2/3
AT8901/2/3 CLI Reference Manual
Page 6 - 10
NOTE: When you change the timeout value, the new value is applied to all
active and inactive sessions immediately. Any sessions that have been
idle longer than the new timeout value are disconnected immediately.
Default
5
Format
telnetcon timeout <1-160>
Mode
Privileged EXEC
6.3.8.1
no telnetcon timeout
This command sets the Telnet connection session timeout value to the default.
NOTE: Changing the timeout value for active sessions does not become effec-
tive until the session is reaccessed. Also, any keystroke activates the
new timeout duration.
Format
no telnetcon timeout
Mode
Privileged EXEC
6.3.9
disconnect
Use the
disconnect
command to close Telnet or SSH sessions. Use
all
to close all
Telnet and SSH sessions, or use
<session-id>
to specify the session ID to close. To
view the possible values for
<session-id>
, use the
show loginsession
command.
Format
disconnect {<session_id> | all}
Mode
Privileged EXEC
6.3.10
show telnet
This command displays the current outbound Telnet settings. In other words, these
settings apply to Telnet connections initiated from the switch to a remote system.
Format
show telnet
Modes
Privileged EXEC
User EXEC
Outbound Telnet Login Timeout Indicates the number of minutes an outbound Tel-
net session is allowed to remain inactive before being logged off.
Maximum Number of Outbound Telnet Sessions Indicates the number of simulta-
neous outbound Telnet connections allowed.
Allow New Outbound Telnet Sessions Indicates whether outbound Telnet sessions
will be allowed.
6.3.11
show telnetcon
This command displays the current inbound Telnet settings. In other words, these
settings apply to Telnet connections initiated from a remote system to the switch.
Format
show telnetcon
Modes
Privileged EXEC
User EXEC