7 backlight connector, 8 display default settings, Pitx-sp user's guide – Kontron pITX-SP User Manual
Page 21
Advertising
KTD-S0002-I Page
16
Graphics
Interface
p
ITX-SP User's Guide
6.7
Backlight Connector
Backlight is available through the J1801 connector (7 pins). An external voltage source must be used to
supply the backlight with +5V or +12V.
Header
Pin
Signal Name
Function
1
N.C.
Not connected
2
BKLTADJ
Brightness control (0V - +5V)
3
GND
Ground
4
N.C.
Not connected
5
N.C.
Not connected
6
GND
Ground
1
7
7
BKLTON
Backlight on/off
6.8
Display Default Settings
On the first boot-up a DVI monitor must be connected to the pITX-SP. The simultaneous mode is not sup-
ported by Intel
®
. During the boot process respectively DOS mode the VGA BIOS only allows a DVI monitor or
a flat panel.
Advertising