Kontron pITX-SP - Manual (Page 37)

KTD-S0002-I Page 32 Power Supply
p ITX-SP User's Guide
14.4 Battery Connector
The battery interface is available through the pin strip J1800 (2 pins).
Header Pin Signal Name Function
1 VBAT 1) Battery input voltage +3V
1 2
2 GND Ground
Note: 1) To protect the external power lines of peripheral devices make sure that
- the wires have the right diameter to withstand the maximum available current.
- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.
When the board is shipped the RTC battery is mounted on the RTC battery module.
Battery