4 usb client interface – Kontron pITX-SP User Manual
Page 23
KTD-S0002-I
Page 18
USB Interface
p
ITX-SP User's Guide
7.4
USB Client Interface
Following steps are necessary to prepare a connection:
Invoke the BIOS Setup and set Advanced/Onboard Device Configuration/USB Configuration/
USB Client Controller to Enabled.
Use
following
cable
wiring.
Pin pITX-SP (J3303)
Pin Host Computer
Comment
1
1
GND
3
2
USB-
2
3
USB+
4
---
Don't connect these pin
Use USB_Client.zip, start Setup.exe from the directory XPPro and install the client software on
the pITX-SP. For more information see the including documentation USBC_ReleaseNotes.pdf.
Use USB_Client.zip, start Setup.exe from the directory XPPro/hostwizard and install the host
software on the host computer.
The only operating mode which is approved by KONTRON is RNDIS-only mode.