Kontron SMARC Evaluation Carrier - Manual (Page 25)

User’s Guide
25 www.kontron.com
Connector: Molex 39-30-3045, 4.2mm pitch R/A through-hole header.
Pin Number Signal Notes
1 Module Power 3.0V to 5.25V may be independent of Carrier power.
2 GND
3 Carrier Power 3.0V to 5.25V may be independent of Carrier power.
4 GND
Caution! When power is brought in through the J29 Bench Power Supply connector, then jumpers J56 and J57 must be
open.
5.8 HDMI Connection
The SMARC Evaluation Carrier implements an industry standard HDMI connector.
5.9 Parallel LCD
The SMARC Evaluation Carrier brings the SMARC Module parallel LCD signals to a 40 pin 1mm pitch header that can be
cabled to. The parallel LCD signals are also routed to a pair of LVDS transmitters on the Carrier, allowing dual
channel LVDS to be realized.
The color mapping of the parallel LCD data bits are defined in the SMARC specification document.
The parallel LCD data signal level is, per the SMARC specification, at V_IO, which typically is 1.8V. The 40 pin LCD header
has pins with 1.8V and 3.3V supply voltages for the panel. All signals listed below are at V_IO level.
There are no backlight supply voltages or control pins on the 40 pin connector. There is a separate connector, J33, for
supplying voltages to the backlight.
Connector: JST BM40B-SRDS-A-G-TF, 1mm pitch 2 row (20x2) SMD vertical header.
Pin Number Signal Notes
1 LCD Data 0 BLU0 (LS bit)
2 LCD Data 1 BLU1
3 LCD Data 2 BLU2
4 LCD Data 3 BLU3
6 LCD Data 4 BLU4
7 LCD Data 5 BLU5
8 LCD Data 6 BLU6