Kontron SMARC Evaluation Carrier - Manual (Page 51)

User’s Guide
51 www.kontron.com
13 Camera Mezzanine
The Camera Mezzanine is a 50mm x 26mm board that allows various cameras, serial and parallel, to be prototyped with
the SMARC Evaluation Carrier board.
Vendor Vendor P/N Connector type Kontron PN
Hirose FX12B-60P-0.4SV SMARC carrier connector 1052-2681
Hirose FX12B-60S-0.4SV Camera Mezzanine Module connector 1052-2683
The separation between the SMARC Evaluation Carrier top side and the Camera Mezzanine PCB bottom side is 1.5mm.
Standoffs with threads for M2.5 hardware are present on the Evaluation Carrier. There are no parts on the Evaluation
Carrier in the shadow of the Camera Mezzanine, except for the mating Hirose connector and the standoffs. Hence parts
up to 1.3mm tall may be placed on the bottom side of the Camera Mezzanine PCB. On the top side, a part height limit of
6mm is advised.
If through hole parts are used on the Camera Mezzanine PCB, be careful that the solder tits do not touch the surface of
the Evaluation Carrier. Through hole parts are not advised.
A camera may be mounted directly to the Camera Mezzanine for test, or cabled to the Camera Mezzanine. Flex circuits or
rigid-flex circuits can be considered, to allow camera(s) mounting.