Kontron KISS Stor 1 User Manual
Page 31
Installing the KISS-Stor 1
30
KISS-Stor 1 – User’s Manual
8.
Slide the drives cage of the KISS-Stor 1 into the removed drive cage of the
computer. Align the front of the drives cage of the RAID subsystem with the
front of the drive cage of the computer.
Make sure that you don't mount the drives cage of the KISS-
Stor 1 upside-down in its intended location (refer to the
fig. 7
).
The KISS-Stor 1 is designed to be used in horizontal position.
9.
When the drives cage of the RAID subsystem is lined-up correctly, secure it to
the drive cage of the computer using four of the M3 metric supplied screws.
Check the alignment before you tighten the screws.
10.
Remount the drive cage into the computer case using the retained screws
(refer to step 3). Check the alignment before you tighten the screws.
11.
Replace the system case cover by use of the retained screws, if the internal
connection procedure is performed (refer to “KISS-Stor 1 Connection
Procedure”).
Before replacing the case cover to your system, you should first
become familiar with the unit and check that everything is
connected properly.
Following a proper cabling procedure will prevent a false power-
on condition, which could result in unit operational failure.
The KISS-Stor 1 RAID subsystem is not equipped with a power
switch.