Kontron KISS Stor 1 - Manual (Page 34)

Installing the KISS-Stor 1
KISS-Stor 1 – User’s Manual 33
KISS-Stor 1 Connection Procedure
Before attempting to connect the KISS-Stor 1, the computer
must be powered-down and the power cord has to be
disconnected from the power source.
Serial ATA Cable Connection
Follow these steps to connect the SATA cable and the optional 3-pin serial cable
connector:
1. Turn off the and disconnect the power cord from power source.
2. Insert the SATA cable (not included) to the SATA port of the
motherboard/Single Board Computer (SBC) of the computer (depending on
the computer configuration).
3. Connect the other end of the SATA cable to the SATA port of the
KISS-Stor 1 RAID subsystem (refer to fig. 14, pos. 2 ).
2
1
3
Fig. 14: KISS-Stor 1 – Connections between KISS-Stor 1and computer system
The KISS-Stor 1 RAID monitoring can be performed via the
SATA port, if the RAID subsystem is installed into a
computer with on-board Intel® SATA controller (ICH5-ICH7).
1 KISS-Stor 1 (rear)
2 SATA cable connection
3 Power source connection
1x 4-pin connector