Vermont Casting 2505G - Manual (Page 16)

Tools needed:
Assembly Step 11
16
Locate these parts: HARDWARE BAG G
Pliers
Zip Tie
OR
Using the zip tie, secure the hose to
the front leg as shown. Do not pull the
zip tie tight - leave it just loose
enough so that the hose can be
adjusted if needed.
Tying the hose to the leg helps
prevent the hose from coming into
contact with the hot burner chamber.
Inspect the installation underneath
the smoker to ensure that the hose is
not rubbing any portion of the burner
chamber.
1. Place one end of the S-Hook
around the regulator neck or
hose as shown.
2. Using a set of pliers, crimp the
S-Hook securely to the HVR
so that it can not be removed
from the HVR.
3. When an LP tank is not
attached to the smoker, use
the S-Hook to hang the HVR
from the carry handle on the
side of the smoker. This will help
prevent dirt and other particles from
plugging the end of the HVR.
S-Hook
Assembly is now complete! Please follow all instructions
and safeguards on the following pages for connecting
the LP tank.
Crimp