Vermont Casting 2505G - Manual (Page 7)

Hardware:
Tools needed:
Assembly Step 2
7
HARDWARE BAG
Phillips Head
Screwdriver
1. Set the cabinet assembly top side down.
2.
3. DO NOT yet insert the two bolts in the
locations indicated. These two bolts will
be used in the next assembly step.
For each leg, line up the holes
and insert the bolts. Nuts are
pre-welded to the cabinet.
One leg
contains an extra hole
on its side and must be
mounted at the front in
the position shown.
This hole will later be
used to secure the
gas hose to the leg
with a zip-tie.
IMPORTANT:
Locate these parts:
Cabinet
Assembly
4 Legs
Leg with
extra hole
1/4-20 x 5/8” Bolts
16 Required
A