Vermont Casting 2505G - Manual (Page 8)

Hardware:
Tools needed:
Assembly Step 3
Locate these parts:
Phillips Head
Screwdriver
1. Place the Control Panel Assembly between
the front legs as shown. There are slots on
the control panel that fit around the legs. The
mounting tabs fit to the inside of the legs and
line up with the bolt holes.
2. Be sure all the tabs on the back side
of the control panel are
captured around the legs
as shown below.
3. Insert the two remaining
bolts and tighten them
securely.
8
Control
Panel
Assembly
HARDWARE BAG
1/4-20 x 5/8” Bolts
(2 Remaining from previous step)
A