Losi LOSB0224T2 - Manual (Page 7)

EN
tUning, adjUsting & Maintaining yoUR vEhicLE
• Examine your vehicle on a regular basis.
• Use a brush to remove dirt and dust.
• Look for damage to suspension arms and other molded parts.
• Re-glue the tires to the wheels if necessary.
• clean and oil all wheel bearings.
• Use suitable tools to tighten fasteners.
• Make sure camber and steering linkages are not bent. Replace any bent
linkages.
• Adjust Toe and camber settings if necessary.
• Remove the shocks and inspect them for damage. Rebuild shocks if oil is
leaking.
• Inspect electronics and batteries for exposed wires. Repair exposed wires
with shrink-wrap or replace the wire.
• Make sure the ESc and receiver are secure on the chassis. Replace the
double-sided tape if necessary.
• Power on the transmitter. If the green LED is dim or off, replace the AA
batteries in your transmitter.
• check the spur gear and pinion gear for wear.
sERvicE/REPaiR
Radio/Speed Control & Motor
If you have any problems other than those covered in the troubleshooting
section, please call the appropriate electronics service department. They will
be able to give your specific problem additional attention and instruct you as
to what needs to be done.
Maintenance
If you have any questions other than those covered in the troubleshooting or
maintenance sections, please call the appropriate Horizon product support
department.
Cleaning
Performance can be hindered if dirt gets in any of the moving suspension
parts. Use compressed air, a soft paintbrush, or toothbrush to remove dust
or dirt. Avoid using solvents or chemicals as they can actually wash dirt into
the bearings or moving parts as well as cause damage to the electronics.
Troubleshooting Guide
Problem Possible cause Solution
Vehicle doesn’t operate Battery not charged or plugged in charge battery/plug in
Receiver switch not “On” Turn on receiver switch
Transmitter not “On” or low batteries Turn on/replace batteries
Motor runs but rear wheels
don’t move Pinion not meshing with spur gear Adjust pinion/spur mesh
Pinion spinning on motor shaft Replace pinion gear on motor
Slipper too loose check & adjust slipper
Transmission gears stripped Replace transmission gears
check and replace drive pin
Steering doesn’t work Servo plug not in receiver check if plug in/in all the way
Servo gears or motor damaged Replace or repair servo
Won’t turn in one direction Servo gears damaged Replace servo
Motor doesn’t run Motor plugs loose Plug in completely
Motor wire broken Repair or replace as needed
ESc damaged contact Horizon Hobby Product Support
ESc gets hot Motor over-geared Use smaller pinion on motor
Driveline bound up check wheels, suspension, and transmission
for binding
Poor run time and/or sluggish
acceleration NiMH pack not fully charged Recharge battery
charger not allowing full charge Try another charger
Slipper slipping too much check/adjust slipper
Motor worn out Replace motor
Driveline bound up check wheels, transmission for binding
Poor range and/or glitching Transmitter batteries low check and replace
Transmitter antenna loose check and tighten
Vehicle battery low Recharge or replace
Loose plugs or wires check motor and power plugs
Slipper won’t adjust Drive pin missing in shaft Replace drive pin
Spur gear face worn out Replace spur gear and adjust slipper
7
Losi Mini 8ight BRUshLEss BUggy• instRUction ManUaL