Losi LOSB0207 - Manual (Page 3)

STEP 1 STEP 2
Step 3.1
Once the battery is charged, remove the body clip from
the front battery hold-down and lift the battery
strap (fig. 1).
Step 3.2
Install the charged battery pack into the chassis as
shown (fig. 2). Ensure the battery is laying flat on
the chassis.
Step 3.3
Reinstall the battery strap and body clip. Plug the
battery pack into the ESC (fig. 3).
STEP 3
Fig 1
Fig 2
Fig 3
3
Remove the transmitter battery cover, install
four (4) AA batteries (Pay close attention to
the polarity of the positive (+) and negative (-)
ends) and replace cover.
Plug the charger into the proper wall
receptacle then the battery into the charger
and let it charge for 3 hours for the first time.
For subsequent charges allow 5 to 6 hours
for a full charge.
Getting Started
Fig 1
Fig 2
Fig 3