Losi LOSB0207 - Manual (Page 4)

Brake/Reverse
If the rear wheels turn during power-on, adjust the
“TH. Trim” knob located to the lower right of the
steering wheel until they stop.
To make the vehicle move forward, pull the trigger
back. To reverse the vehicle, wait for the model to
stop and then push the trigger forward.
When going forward the vehicle should move in a
straight line. If not, adjust the “ST. TRIM” so that it
tracks in a straight line without having to turn the
steering wheel.
After you have finished, turn the Mini
HIGHroller off FIRST by sliding the ESC
switch to the “OFF” position. After the model has
been turned off, turn off the transmitter.
If you wish to clean your Mini HIGHroller , use
compressed air and/or a soft paintbrush to remove
dust and dirt. NEVER use chemicals or anything
wet as it can cause damage to both electronics and
plastic parts.
Always turn on the transmitter first.
The small red and green lights above the switch
should both light up. If not, you need to check for
low or incorrectly installed batteries.
Once the transmitter has been powered on, turn on
the Mini HIGHroller by sliding the switch on the
ESC to the “On” position.
ALWAYS
• Turn on the transmitter before the vehicle
• Use caution when running your vehicle near
people
• Turn both the Mini HIGHroller and transmitter
“Off” when done
• Check the battery condition of the transmitter
before running
Never
• Operate the Mini HIGHroller with
low battery power
• Run the Mini HIGHroller through water
or wet grass
• Use chemicals to clean the chassis
• Run the Mini HIGHroller without a gear cover
STEP 4 STEP 5
STEP 6
Off On
Off On
TH Trim
ST Trim
Brake/Reverse
Forward Forward
L
ef
t
Rig
ht
L
ef
t
Rig
ht
STEP 7
STEP 8
4