Losi LOSB0207 User Manual
Page 6
The Transmitter
1.
Steering Wheel: Controls direction (left/right)
of the model.
2.
Throttle Trigger: Controls speed and direction
(forward/ reverse) of the model.
3.
Antenna: Transmits signal to the model.
4.
On/Off Switch: Turns the power on/off for the
transmitter.
5.
Indicator Lights: Green (right) light indicates
adequate battery power. Red (left) indicates
signal strength.
6.
ST. Trim: Adjusts the “hands off” direction of
the model.
7.
TH. Trim: Adjusts the motor speed to stop at
neutral.
8.
Steering Rate: Adjusts amount front wheels
move when the steering wheel is turned left and
right.
9.
ST. REV: Reverses the function of the steering
when the wheel is turned left or right.
10.
TH. REV: Reverses the function of the speed
control when pulled back or pushed forward.
11.
Bottom Cover: Covers and holds the
batteries that power the transmitter.
1
3
10
9
6 7
8
5
4
11
2
6
Radio System Binding
The Losi Radio System with Spektrum 2.4GHz DSM included in the Mini HIGHroller operates on a frequency of
2.4GHz, and provides 79 different “channels” which are automatically selected when the transmitter and vehicle are
turned on. The communication between the transmitter and receiver starts in the few seconds after the transmitter
and vehicle are both turned on. This is called the “binding process”. The Losi DSM radio system will not interfere
with previous technology radio systems that operate on 27MHz or 75MHz frequencies and you will not receive any
interference from them. Although set at the factory, below are the steps required to re-bind your transmitter to the
receiver should the need arise. During the bind process there is a unique ID from the transmitter communicated to the
receiver to ensure trouble free radio operation.
Steps to Re-Bind
1.
Ensure that the transmitter and vehicle are both turned off.
2.
Using the supplied Bind plug (which looks like a standard receiver plug with a wire loop installed) insert or plug
into the receiver slot labeled “BIND”. Looking down on the receiver this slot would be below the LED and is the
furthest from the LED, or nearest to the corner of the receiver.
Note: you do not need to remove any of the other plugs to re-bind.
3.
With the Bind plug installed, turn on the vehicle. Notice a blinking Orange LED within the receiver.
4.
Now you are ready to turn on the transmitter. You should notice on the back of the transmitter a similar blinking
Orange LED under the translucent cover.
5.
Both the receiver and transmitter blinking Orange LED will stop blinking and become solid indicating they have
“bound” themselves together.
6.
Please turn off both the vehicle and transmitter to remove the Bind plug from the receiver. Failing to remove the
Bind plug will cause the transmitter to attempt to rebind every time you turn on the vehicle and transmitter.
7.
Turn on both the vehicle and transmitter to ensure operation. If the transmitter does not control the vehicle,
please repeat steps 1 to 6. Should this not correct the problem, please call Horizon Service/Repair for further
assistance.
8.
The Bind process is complete. Your vehicle’s radio system should be ready for use.