Mercedes-Benz E-Wagon 2014 Owners Manual - Manual (Page 116)

Adjusting with COMAND
The multicontour seat function is only
available on the driver's side.
You can adjust the active multicontour seat
using COMAND. You can find further
information in the separate COMAND
Operating Instructions.
Adjusting the 4-way lumbar support
: To raise the backrest contour
; To soften the backrest contour
= To lower the backrest contour
? To harden the backrest contour
You can adjust the contour of the front seat
backrests individually to provide optimum
support for your back.
Folding bench seat in the cargo
compartment (Wagon)
Important safety notes
G WARNING
If the backrests of the rear bench seat are not
locked in the upright position, the backrest
may fold down while driving. In this case, the
seatbelt may not perform its intended
protective function. There is an increased risk
of injury.
Make sure that the backrests of the rear
bench seat are locked in the upright position.
The folding bench seat in the cargo
compartment is only suitable for persons no
more than 4.6 ft (1.40 m) tall and weighing a
maximum of 110 lb (50 kg).
Observe the loading guidelines
(
Y
page 298).
The maximum permissible weight available
for passengers may be reduced by extensive
optional extras and the vehicle load. Observe
the maximum gross vehicle weight and the
gross axle weight rating, which can be found
on the vehicle identification plate
(
Y
page 416).
The combined cargo cover and net must be
installed if you are using the folding bench
seat (
Y
page 308).
Folding out the folding bench seat
X Make sure that the backrests of the rear
bench seat are locked in the upright
position.
X
Move the handle for the combined cargo
cover and net upwards (
Y
page 308).
X Pull release handle : and fold the
backrest of the folding bench seat
upwards.
114
Seats
Se
ats,
ste
eri
ng
whe
el
an
d
mirro
rs