Mercedes-Benz E-Coupe 2011 Owners Manual - Manual (Page 315)

installed is not the same as the current tire
pressure for the spare wheel.
TPMS warning messages
If the TPMS detects a significant pressure
loss on one or more tires, a warning message
is shown in the multifunction display. In
addition, a warning tone sounds and the tire
pressure warning lamp lights up in the
instrument cluster.
Each tire in which a significant pressure loss
has been detected is highlighted with a red
triangle.
Restarting the tire pressure monitoring
system
G Warning
It is the driver's responsibility to set the tire
inflation pressure to the recommended cold
tire inflation pressure. Underinflated tires
affect the ability to steer or brake the vehicle.
You might lose control over the vehicle.
When you restart the TPMS, all existing
warning messages are deleted and the
warning lamps go out. The currently set tire
pressures are adopted as the specified values
for monitoring.
The TPMS must be restarted when you set the
tire pressure to a new value (as a result of
changed handling or load characteristics, for
example). The TPMS then monitors the new
tire pressure values.
Restart the TPMS after the tire pressure has
been set, as desired, according to the
recommended values for the driving
conditions (
Y page 306). Only correct tire
pressures on cold tires. Comply with the tire
pressures recommended on the Tire and
Loading Information placard on the B-pillar on
the driver's side. Additional tire pressure
values for driving at high speeds or with heavy
loads can be found in the tire pressure table
on the inside of the fuel filler flap.
X Make sure that the tire pressure is set
properly for all four wheels.
X Make sure that the key is in position 2 in
the ignition lock.
X Using = or ; select the Serv.
menu.
X Using 9 or : select Tire
Pressure.
X Press the a button.
The current tire pressure for each wheel or
the
Tire pressures will be
displayed after driving a few
minutes message appears in the
multifunction display.
X Press the : button.
The
Use Current Pressures as New
Reference Values message appears in
the multifunction display.
X To confirm selection: press the a
button.
The
Run Flat Indicator Restarted
message appears in the multifunction
display.
After driving for a few minutes, the system
confirms that the current tire pressure
values are within the specified range. The
new tire pressure values are then accepted
as reference values and monitored.
X To cancel restart: press the X button.
i If the positions of the wheels on the
vehicle have been changed, the tire
pressure may be shown in the wrong
position briefly. This will be corrected after
driving for a few minutes and the tire
pressure will be displayed in the correct
position.
Maximum tire pressures
G Warning
Never exceed the maximum tire inflation
pressure. Follow recommended tire inflation
pressures.
Tire pressures
313
Tires and wheels
BA 207 USA, CA Edition B 2011; 1; 3, en-US
d2sboike
Version: 3.0.3.6
2010-05-20T10:38:09+02:00 - Seite 313
Z