Mercedes-Benz CL-Class 2009 - Manual (Page 318)

Lighting
316
X Press button 3 .
The passenger-side exterior rear view
mirror is selected.
X Adjust the passenger-side exterior rear
view mirror with adjustment button
2 so
that you see the rear wheel and the road
curb.
X Press memory button M 1 .
X Within 3 seconds, press bottom of
adjustment button
2 .
The parking position is stored if the mirror
does not move.
i If the mirror does move, repeat the above
steps. After the setting is stored, you can
move the mirror again.
Lighting
Notes
i If you drive in countries where vehicles
drive on the other side of the road than the
country where the vehicle is registered, you
must have the headlamps modified for
symmetrical low beams. Relevant
information can be obtained at any
authorized Mercedes-Benz Center.
i The active Bi-Xenon headlamps monitor
the vehicle’s steering angle and speed,
then automatically shift their beams to
either side to better follow the curvature of
the road ahead, increasing usable
illumination over conventional headlamps.
Exterior lamp switch
$ a Standing lamps, left
% g Standing lamps, right
& M Off
Daytime running lamp mode
( * Automatic headlamp mode
Daytime running lamp mode
) C Parking lamps (also tail lamps,
license plate lamps, side marker
lamps and instrument panel lamps)
* B Low-beam headlamps or high-beam
headlamps
, ¥ Front fog lamps
. † Rear fog lamp
i The exterior lamps go out automatically
when you remove the SmartKey from the
Controls in detail