Mercedes-Benz SL-Class 2009 Owners Manual - Manual (Page 145)

Control system
143
You can connect your telephone via Blue-
tooth
® to the COMAND system, see separate
COMAND system operating instructions.
X Switch on the COMAND system.
See separate COMAND system operating
instructions.
X Press button ÿ or è on the multi-
function steering wheel repeatedly until the
message TEL appears in the left multifunc-
tion display.
One of the following messages will appear
in the multifunction display:
R
No Service: No network is available.
R Bluetooth Ready: The telephone has
not been connected to the COMAND sys-
tem via Bluetooth
® yet.
X Connect the telephone to the
COMAND system via Bluetooth
® .
R Ready or name of the network provider
(if available): The telephone has found a
network and is ready for use. You can
operate it using the control system.
Answering a call
When your telephone is ready to receive calls,
you can answer a call at any time. In the right
multifunction display you will then see the
message, or if available, the caller ID (number
and name):
X Press button s .
You have answered the call.
Ending a call or rejecting an incoming
call
X Press button t .
Dialing a number from the phone book
If your telephone is ready to receive calls, you
may select and dial a number from the phone
book. You can add new numbers to the phone
book with the telephone, see separate oper-
ating instructions.
X Press button ÿ or è on the multi-
function steering wheel repeatedly until the
message TEL appears in the left multifunc-
tion display.
X Press button j or k repeatedly until
the desired name appears in the right mul-
tifunction display.
If you press and hold button
j or
k for longer than 1 second, the system
scrolls rapidly through the list of names
until you release the button again.
The stored names are displayed in ascend-
ing or descending alphabetical order.
X Press button s .
The control system dials the selected
phone number.
If the connection is successful and this fea-
ture is supported by your network provider,
the name of the party (if stored in your
phone book) you are calling will appear in
the multifunction display.
The control system stores the dialed num-
ber in the redial memory.
or
X Press button t if you do not want to
make the call.
Controls in detail
Z