Mercedes-Benz CLK-Class 2006 Owners Manual User Manual
Page 449
448
Practical hints
Flat tire
1 Wheel wrench
̈
On wheel to be changed, loosen but do
not yet remove the wheel bolts (ap-
proximately one full turn with wrench).
The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.
2 Jack
3 Take-up bracket
̈
Place jack
2 on firm ground.
̈
Position jack
2 under take-up
bracket
3 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an
incline.
̈
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while
vehicle is raised.
Warning!
G
The jack is intended only for lifting the vehi-
cle briefly for wheel changes. It is not suited
for performing maintenance work under the
vehicle.
ț
Never start the engine when the vehicle
is raised.
ț
Never lie down under the raised vehicle.