Oldcastle BuildingEnvelope AD-375 Thermal Entrance - Manual (Page 13)

Series 3000 XT DOOR FRAME ASSEMBLY
1. When installing 3000 XT door frame without transom use AD-454 jambs and door header
2. Attach (2) AC-133-01 shear blocks to top end of door jambs using (4) FS-9 #14 x 1 1/2" hex
head fasteners. See FIGURE 7 below.
3. Attach AD-204-01 left hand or AD-205-01 right hand threshold clips to bottom of door jamb
using (2) FS-62 #10 x 1/4" flat head machine screws. See FIGURE 3, pg 8.
4. Apply sealant along exterior and interior faces of shear blocks as shown in FIGURE 2, pg 8.
5. Assemble door header to jambs by sliding header over shear blocks and attaching using (2)
FS-7 #10 x 3/4" flat head screws. Clean excess sealant from exposed surfaces after assembly.
6. Attach threshold to clips using (1) FS-62 #10 x 1/4" flat head fasteners, See FIGURE 4, pg. 8.
Note; threshold will be removed once frame is installed into opening to seal and drill for
anchors.
FIGURE 7
Shear block installation
AC-133-01
FS-9
3/8"
5/16"
7/8" 5/16"
7/8"
Drill #11 (.191Ø) holes
Phone: 1-866-OLDCASTLE (653-2278)
Web Address: www.oldcastlebe.com
11 MAY 2013
AD-375 THERMAL DOOR
(2) FS-7
AD-454
AD-454