QOMO QD3300 - Manual (Page 13)

13
PROJECTOR ON/STANDBY
Press the “POWER” button to turn on the visualizer’s power and press the
“Ppw” button to turn the projector power on. To place the projector on
standby after
the use, press the “Ppw” button and hold for more than 2
seconds. (Using the remote control, press the “PROJECTOR POWER”
button)
PROJECTOR INPUTS SELECTION
When the projector is connected to several input sources, use the “Pin”
button to switch between projector signal inputs. (Using the remote control,
press the “PROJECTOR INPUT” button)
IMAGE ROTATION
In order to rotate the image, press the “Rot” button once, the displayed
image will be rotated ±180 degrees clockwise. Continue to press the
“Rot” button to restore the image to its initial position.
IMAGE REVERSION
To display a vertically mirrored image, press the “MIRROR” button. Press
the “MIRROR” button again to exit.
INFRARED REMOTE CONTROL
The visualizer’s remote control can control the camera from different
angels. On the left side of the visualizer stage, there is a built-in remote
control storage compartment where you can store the remote control when
it is not in use.
Please note that an infrared remote control can only be used up to a
certain distance to the unit. Objects situated between the visualizer and the
infrared remote control and a weak battery may interfere with the reception.
4 X 4 MULTIPLE SCREEN DISPLAY
Press “DIV.”, the stored images can be displayed in a 4 x 4 matrix. Press