QOMO QRF300 - Manual (Page 69)

Copyright © 2009 All Rights Reserved by QOMO HiteVision.
www.qomo.com 69
Note: Once the new ID has been set successfully, the color of the Set button changes to green. If
the set up is failure, the color changes to red.
2.4.2.3 Channel Set
To set the host main receiver channel number and the band number, follow these steps:
1. From the main QClick window, select Settings tab, then click Remote ID to display the Set
Remote ID window.
2. Select the Channel Set tab.
3. The software will prompt you to login again to double check if you have the authority to
change the main receiver channel.
4. After login, the Set Remote ID window displays. Enter the new channel number into the text
box next to the Channel No.. Then click the Send button .
5. If you want to set a new band for the setting channel. Enter the new band number into the
text box next to the Band. Then click the send button
6. Click the Close button to close the setting.
Note: The valid channel number is from 0 to 49 and the valid band number is from 0 to 3.