Rice Lake 520 HMI Digital Weight Indicator Installation Manual - Manual (Page 61)

Table 9-8. SETPNTS EDP Commands
Command Description Values
SETPOINT Setpoint number 1–8
KIND Setpoint kind OFF, GROSSSP, NETSP, +RELSP, –RELSP, %RELSP, PAUSE,
DELAY, WAITSS, COUNTER, AUTOJOG, COZ, INMOTON,
INRANGE, –GROSS, –NET, BATCHPR, TIMER, CONCUR
VALUE Setpoint value number
PSHTARE Push tare OFF, ON
PSHPRINT Push print OFF, ON, WAITSS
PSHACCM Push accumulate OFF, ON, ONQUIET
TRIP Trip HIGHER, LOWER, INBAND, OUTBAND
BANDVAL Band value number
HYSTER Hysteresis number
ALARM Alarm OFF, ON
PREACT Preact OFF, ON, LEARN, FLOW
PREVAL Preact value number
PREADJ 1-100%
PRESTAB 0-65535
PREBAND number
PRECOUNT 1-65335
BATCH Batch enable OFF, ON
BATSTART Batch step enable See Section 11.0 on page 65 for detailed information
BATPAUSE Batch step pause
BATRESET Batch step reset
BATSTATUS Batch status
NAME Setpoint name number NONE, 1–8
ACCESS Setpoint access OFF, ON, HIDE
DIGOUT Digital output NONE, 1–4
RELNUM Relative setpoint number 1–8
START Starting setpoint 1–8
END Ending setpoint 1–8
BATCHNG Batching mode OFF, AUTO, MANUAL
Table 9-9. PFORMT EDP Commands
Command Description Values
GFMT Gross demand print format string See Section 10.2 on page 62 for detailed information
NFMT Net demand print format string
CFMT Count format string
SPFMT Setpoint print format string
EDPFMT EDP demand print format string
HDRFMT Ticket header format string
STRMFMT Custom stream format string
55 520 Indicator Installation Manual