Rice Lake 880 Performance Series Panel Mount Indicator/Controller - EtherNet/IP Interface Option Installation and Programming Manual - Manual (Page 20)

16 EtherNet/IP Installation and Programming Manual
4.2.2 Status Data
Indicator status data is returned in the second word (see Table 4-4). Batch commands
return batch status in place of the low byte (see Table 4-5). Setpoint commands return
batch status in the low byte of the status word and the setpoint number in the high
byte.
Bit-0 Errors
• PLC command failed to execute.
• No configuration has taken place.
• Scale parameter is out of range.
• Print error has occurred.
• Load error has occurred.
• Memory error has occurred.
• Analog to digital converter error.
• Tare error.
• Scale over range error.
• Scale under range error.
• Non-recoverable configuration store error.
• Indicator in configuration mode.
Word 2
Bit
Indicator Status Data
Value=0 Value=1
00 Error **
(see See “Bit-0 Errors” on
page 16.)
No error
01 Tare not entered Tare entered
02 Not center of zero Center of zero
03 Weight invalid Weight OK
04 Standstill In motion
05 Primary units Other units
06 Tare not acquired Tare acquired
07 Gross weight Net weight
08 Channel number
Least significant bit first.
09
10
11
12
13 Not used
14 Integer data Floating point data
15 Positive weight Negative weight
** This error condition does not necessarily mean the weight
being reported is invalid. Refer to the “Weight invalid” bit.
Table 4-4. Indicator Status Data Format
Note